How to troubleshoot stuck piston in FY pneumatic slurry pump?
The FY series <a href="/en/products/fy-slurry-pump/" title="FY Series Pneumatic Slurry Pump">pneumatic slurry pump</a>s may experience piston sticking issues during high-viscosity material transfer. Common causes include material solidification and foreign object obstruction.
For complete piston seizure, first depressurize the system and disassemble the pump cover. Clean piston assembly with solvent and replace damaged O-rings (spec Φ25×3.1). Apply food-grade lubricant during reassembly.
When encountering rough movement with abnormal noise, check piston rod surface for burrs (standard diameter Φ16-0.02/-0.04mm). Replace worn PTFE guide bushings and replenish SY-1 silicone grease (5g per maintenance).
For startup difficulties after shutdown, implement pre-shutdown flushing with cleaning solvent. Inspect and replace swollen FKM seals. In cold environments (-5°C and below), switch to low-temperature grease.
If experiencing reduced discharge with normal piston movement, verify air supply pressure (≥0.4MPa). Measure seal compression (0.3-0.5mm preload) and rotate 180° for even wear distribution. Consider upgrading to hard alloy piston rings for abrasive media.