How to troubleshoot oil suction failure in electric liquid pumps?
When SB series or YL adjustable electric liquid pumps fail to suction oil, it typically involves pipeline systems, mechanical components and electrical systems. The most common symptom is normal operation without liquid output, usually caused by air leakage in suction pipelines.
For motors running but impellers not working, check drive shaft breakage or coupling detachment. Thick medium residue often causes impeller jamming. SB series requires 12mm hex wrench for disassembly.
Sudden tripping after startup indicates motor winding short circuit or impeller blockage. Measure three-phase winding resistance (3.2±0.3Ω for SB series) and use megohmmeter for insulation test (>2MΩ).
Gradual flow reduction usually results from pipe or impeller channel blockage. Clean with diesel soaking and use special tool (SB-T01) for impeller cleaning. Preheat oil above 15℃ in winter.
For YL adjustable pumps failing at low speed, inspect carbon brushes (replace if <5mm) and test potentiometer continuity. Carbon brush assembly should be replaced every 2000 operating hours.
New pump failures often come from incorrect priming or motor reversal. Always maintain SB series at vertical insertion angle (±5°) and verify power phase sequence for three-phase motors.