Why does the self-priming sanitary pump fail to suck liquid?
The ZX series self-priming sanitary pump may fail to suck liquid due to various reasons.
First check the priming liquid volume in pump chamber which should reach 2/3 capacity, and inspect mechanical seals (model 104-22/108-25) for wear.
For slow suction, verify suction pipe length doesn't exceed 3 meters and replace inlet rubber seals (Φ32-50mm) if aged.
Sudden loss of self-priming ability usually indicates impeller blockage or damage to pump body rubber seal (Φ130-170mm).
When motor runs but no liquid flows, ensure valves are fully open and liquid viscosity is below 50cSt as specified.
Abnormal vibration requires checking foundation levelness and shaft alignment before restarting.