What causes leakage at motor end of SB electric drum pump?
Leakage at motor end of SB series <a href="/en/products/sb-electric-drum-pump/" title="SB Series Electric Drum Pump">electric drum pump</a>s is typically caused by three main factors: seal failure, bearing wear or installation errors.
For persistent seepage, the primary solution is to replace damaged shaft seals. The procedure involves disassembling the motor end cover, cleaning the seal groove and installing new seals with proper orientation.
When leakage accompanies abnormal noise, bearing replacement is required. Standard 6204ZZ bearings should be used with radial clearance maintained at 0.02-0.05mm.
For new pumps showing early leakage, reassembly with correct torque (5-7N·m) is necessary to ensure even seal compression.
Seasonal leakage variations can be addressed by switching to fluororubber seals and implementing proper warm-up procedures in cold environments.